<strong id="vcd2t"></strong>

  1. <tt id="vcd2t"><noscript id="vcd2t"></noscript></tt>
      <rt id="vcd2t"></rt>
        <rt id="vcd2t"></rt>
          <ruby id="vcd2t"><table id="vcd2t"></table></ruby>
        1. <cite id="vcd2t"><tbody id="vcd2t"><samp id="vcd2t"></samp></tbody></cite>
          <strong id="vcd2t"></strong>

          您的位置:開發工具

          開發工具

          ST-LINK/V2

           The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.

          In addition to provide the same functionalities as the ST-LINK/V2, the ST-LINK/V2-ISOL features digital isolation between the PC and the target application board. It also withstands voltages of up to 1000 Vrms.

          STM8 applications use the USB full-speed interface to communicate with the ST Visual Develop (STVD) or ST Visual Program (STVP) software.

          STM32 applications use the USB full-speed interface to communicate with Atollic®, IAR, Keil®or TASKING integrated development environments.

          Key Features

          • 5 V power supplied by a USB connector
          • USB 2.0 full-speed-compatible interface
          • USB standard A to Mini- B cable
          • SWIM specific features
            • 1.65 V to 5.5 V application voltage supported on SWIM interface
            • SWIM low-speed and high-speed modes supported
            • SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
            • SWIM cable for connection to the application via an ERNI standard vertical connector (ref: 284697 or 214017) or horizontal connector (ref: 214012)
            • SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector
          • JTAG/serial wire debugging (SWD) specific features:
            • 1.65 V to 3.6 V application voltage supported on the JTAG/SWD interface and 5 V tolerant inputs
            • JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector
            • JTAG supported
            • SWD and serial wire viewer (SWV) communication supported
          • Direct firmware update feature supported (DFU)
          • Status LED which blinks during communication with the PC
          • Operating temperature 0 to 50 °C
          • 1000 Vrms high isolation voltage (ST-LINK/V2-ISOL only)

          IMAGE

          [返回]
          亚洲 欧洲 日产国码一本大道,日本道二区高清视频,国产男人的天堂在线视频,青青在线精品2019国产,日本高清成本人视频一区|狠狠狠的在啪线香蕉好男人|韩国欧美日本亚洲一区二区